PHP Settings

PHP settings of websites hosted within the subscription are defined by the php-settings node. This node is specified by complex type phpSettings (plesk_domain.xsd). This type is structured as follows:

webspace_phpSettings

  • The setting node is required. It specifies a certain PHP setting and its value.
    • The name node is required. It specifies a name of a certain PHP setting. Data type: string. You should use the same setting name that is used in the php.ini configuration file. Say, memory_limit, safe_mode, and so on.
    • The value node is required. It specifies a value of a certain PHP setting. Data type: string. You should use the same setting values that are used in the php.ini configuration file. Say, for memory_limit it can be 128M or on for the safe_mode parameter. If you want to set the default value to a PHP parameter, send the request with the blank value node.

 

The following sample packet creates a subscription and sets the memory_limit and safe_mode settings:

<packet>
<webspace>
<add>
   <gen_setup>
      <name>newsite.com</name>
      <ip_address>192.0.2.132</ip_address>
   </gen_setup>
   <php-settings>
      <setting>
         <name>memory_limit</name>
         <value>128M</value>
      </setting>
      <setting>
         <name>safe_mode</name>
         <value>on</value>
      </setting>
   </php-settings>
</add>
</webspace>
</packet>

 

 

Leave your comments on this page

Leave your feedback or question on this documentation topic below. For technical assistance, contact your hosting service provider or submit a request to Plesk support. Suggest new features for Plesk here. Discuss general questions on the Plesk forum. All offtopic comments will be removed.